Case studies

Real duty cycles, measurable results

Six delivered projects — what was failing, what we changed, how long it ran and what it delivered. Every one opens to full specifications and measured results.

LSR seals for a handheld enclosure: 0.3 g parts, ±0.05 mm Electronics

LSR seals for a handheld enclosure: 0.3 g parts, ±0.05 mm

A handheld instrument maker needed 0.3 g LSR seals that stayed watertight after 10,000 button presses. Compression moulding could not hold the tolerance.

±0.05 mmRepeatability
10,000Button cycles, IP67 held
Read the full case →
Ironing-table foam: no water pooling, no collapse Garment finishing

Ironing-table foam: no water pooling, no collapse

Foam pads in a garment plant collapsed within a month and pooled condensate. We replaced them with 10 mm open-cell silicone foam that lets steam pass straight through.

9 moPad life (was 1 mo)
−30%Rework from water marks
Read the full case →
Laminator vacuum bags: from 3-month replacement to 14 months Solar PV

Laminator vacuum bags: from 3-month replacement to 14 months

A German module maker was replacing rubber bags every quarter — EVA outgassing made them tacky and they split along the seam. We specified a 2.5 mm seamless silicone bag.

14 moService life (was 3 mo)
−0.4 ptCell micro-crack rate
Read the full case →
Membrane for an 800 mm mould press: no more corner splitting Woodworking press

Membrane for an 800 mm mould press: no more corner splitting

A US door plant was splitting 1 mm membranes at mould corners within three months. We moved them to 2 mm, 60 Shore A platinum-cured sheet with 800% elongation.

−70%Replacement frequency
−1.2 ptScrap rate
Read the full case →
Filler-line gaskets: serviceable joints that no longer leak Food processing

Filler-line gaskets: serviceable joints that no longer leak

A dairy filler was leaking at clamp joints after every CIP cycle. The gaskets were the wrong compound for caustic wash-down — we changed hardness and compression set.

0Leaks after 200 CIP cycles
−45%Gasket consumption
Read the full case →
Architectural glass bags: transparent, 20-minute changeover Glass lamination

Architectural glass bags: transparent, 20-minute changeover

A Turkish glass plant needed to watch interlayer flow during the cycle. We built 3 mm high-clarity bags to their furnace bed, with a one-piece U-seal edge.

−65%Changeover downtime
20 minBag change, one operator
Read the full case →

Your duty cycle may be harsher

Tell us the failure mode, temperature and cycle count. We reply with a material plan and free samples.

Get your solution