Silicone Cord & O-Ring Cord: Sizing, Hardness and Splicing
How to pick cord diameter, hardness and splice method so a made-to-measure O-ring seals first time — and keeps sealing after 1,000 cycles.

Silicone cord is the fastest way to get a seal of any size without tooling: buy a length, cut it, splice it, fit it. The catch is that three details decide whether the joint leaks.
Diameter and groove fill
For a static face seal, the cord should fill roughly 70–80% of the groove cross-section. Under 65% and the cord will not bridge surface imperfections; over 85% and it will not compress, which is worse — the housing takes the load and the seal takes none.
| Groove width | Suggested cord diameter |
|---|---|
| 3 mm | 2.5 mm |
| 5 mm | 4.0 mm |
| 8 mm | 6.0 mm |
Hardness
50–60 Shore A is the general-purpose range. Go to 70 Shore A for high-pressure or vacuum service where extrusion into the gap is a risk; go to 40 Shore A only for very light closures and large covers where hand force matters.
Splicing: the part people get wrong
Three methods, in order of reliability:
- Vulcanised splice — ends are fused under heat and pressure. Strength approaches the parent material. This is what you want for anything carrying vacuum or pressure.
- Adhesive splice — cyanoacrylate or silicone adhesive. Fast, fine for dust seals, not for vacuum.
- Butt joint without bonding — acceptable only for compression-only dust seals where the joint sits in a corner.
Always position a splice away from a corner or a port. If the seal is critical, specify a vulcanised splice and ask for the joint to be visually inspected at 10× magnification.
Storage matters more than buyers expect
Silicone cord stored in a coil under tension takes a set. Store straight, or on a drum of at least 20× the cord diameter, away from sunlight and ozone sources such as electric motors.
SHINEKIM supplies solid silicone cord from 1.5 mm to 25 mm in translucent, red, black and custom colours, with vulcanised splicing to your finished perimeter.
把图纸或样品寄给我们,48 小时内回复选型与报价。
获取报价

